Product Manual

5’ X 8’ ALUMINUM TRAILER KIT
Owner’s Manual
5’ X 8’ ALUMINUM TRAILER KIT
Owner’s Manual
27. Attach while ground wire at plug end of wiring harness to the small hole on coupler base
(15) with 4mm tapping screw .
28. Leave about 18” of wire beyond the coupler and lay out wire to the channel of tow bar and
side rail as shown . Holes wire to rail with wire clip as circle D .
29. Connect the wire lead from the side running light to the brown wire on each side with the
wire connector . Use pliers to squeeze the connector closed as circle E .
30. Strip end of wire 3/4” for yellow / brown and green / brown wires .
31. Make tail light connections as per color code with connector as circle C .
Left Side
Yellow-yellow wire
Brown- brown wire
White- tighten with tail light bolt
SECTION7: ASSEMBLY CHECK
• Double-check the assembly to be sure all the steps were followed and all the parts are used.
Fully tighten all bolts and nuts.
• Do not remove the VIN sticker from the tow bar.
9 of 14
SECTION6: LIGHT SYSTEM ASSEMBLY
23. Remove the left tail light (24L) from the light bracket (25L), attach the bracket to the left side
rail with M10*25 bolts, ￠10 flat washer and M10 nuts (30, 28, 29 Bolt set A) as shown
below. Install the left tail light and license plate holder (26) (with clear lens facing down) with
M6 padded nuts (38) on the light.
24. Remove the right tail light (24R) from the light bracket (25R), attach the bracket to side right
rail with M10*25 bolts, ￠10 flat washer and M10 nuts (30, 28, 29 Bolt set A) as shown
below. Install the right tail light with M6 padded nuts (38) on the light.
25. Attach the supporting plates(43) to the four corners of the frame and tighten with M10*25
bolts, ￠10 flat washer and M10 nuts (30, 28, 29 Bolt set A).
26. Remove the lenses of the side running lights (27), feed the wire through the hole in the
center of the light and the center hole in the frame and attach the lights to frame with
self-tapping screws (39).Replace the lenses on the lights.
TRAILER LIGHT KIT
WINDOW DIAGRAM AND INSTRUCTION
Check alignment of all parts and install 4-wire vehicle connector in trunk area of your car.
Locate the connector plug near the hitch ball and lay out wires . Connect the brown wire to tail
light by stripping , wrapping and taping connector , similarly connect the yellow wire to left
single & stop light wire and green wire to the right single & stop light wire. Some foreign vehicle
may require an adaptor to convert their 5-wire system to 4-wire vehicle connector.
8 of 14
Right Side
Green-green wire
Brown- brown wire
White- tighten with tail light bolt