Product Manual

Page of 8
5
HOOK UP
1. Attach tow bar to tow bar brackets with two wire lock pins as part#10.
2. Attach tow bar coupler to 2” ball of towing vehicle.
3. Center coupler on tow bar side arms so that tow bar is symmetrical about the
centerline of the vehicles.
4. Tighten the 3/8” nuts which attach the tow bar side arms to the coupler to 31 LB-FT.
5. Install safety chains as described in the next section.
6. Connect an adequate wiring harness so that stop lights, turn signals and taillights
operate on towed vehicle in conjunction with towing vehicle’s lights.
7. Read and follow labels located on tow bar as in below Chapter of TOWED VEHICLE
ATTACHMENT.
SAFETY CHAINS
USE SAFET CHAIN KIT (not included).
1. Connect safety chains to both vehicles and the tow bar itself as shown below.
2. Attach chains to tow bar with 7/16 GR2 U-bolts and flanged locknuts
as shown below. Tighten each flanged locknut until 1/8” of U-bolt
threads extend past locknut.
3. The chains at each vehicle will be looped to themselves using quick
links as shown below. The nuts on the quick links must have full thread
engagement.
4. Cross two chains under coupler and connect to chain bracket on hitch or to frame of
towing vehicle, allowing only enough slack to permit turning.
5. Connect the other two chains to the frame of the towed vehicle as close to the front of
the vehicle as possible. Allow only enough slack to permit the up and down pivoting of
tow bar.
Quick link
Connect to chain bracket on hitch or to frame of towing vehicle
Flanged locknut (8 pcs)
Cross chain under coupler
Quick link
7/16 GR2 U-bolt (4 pcs)
Connect to frame of towed vehicle as close
to front as possible