Product Manual

Page of 8
4
Warning label 1:
READ WARNINGS CAREFULLY.
1. Use only a 2” ball rated for at least 5000 pounds.
2. Properly connect safety chains from tow bar to towing vehicle and towed vehicle.
3. Read and follow label on side of tow bar, coupler and instruction before towing.
Warning label 2:
WARNING! FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN A
HAZARDOUS TOWING CONDITION.
DO NOT REMOVE THIS LABEL.
1. Total weight of towed vehicle must not exceed 5,000 pounds.
2. Towing vehicle must weigh more than towed vehicle.
3. Steering wheel of towed vehicle must be free to turn.
4. Do not allow passengers to ride in towed vehicle.
5. Do not exceed 45 miles per hour.
6. Do not back up with vehicle in tow.
7. Remove tow bar when not towing.
8. Install per instructions provided.
INSTALLATION
TOW BAR
1. Center tow bar on attachment surface, spreading side arms to at least 24”, and mark
tow bar bracket centerlines.
2. Using tow bar bracket as a template, drill two 1/2” holes into attachment surface, each
side.
3. Attach tow bar brackets to attachment surface using the 1/2 x1-3/4 GR5 bolts supplied
with the tow bar, note: if longer bolts are needed, use 1/2-12 GR5 bolts.
4. Fasten the tow bar brackets with flat washers and locknuts as shown below.
5. Tighten these 1/2” fasteners to 75 LB.-FT.
Locknut
Attachment Surface (4 pcs)
Tow bar bracket Flat washer(4 pcs)
(2 pcs)
1/2 x13x3.5
Hex bolt (4 pcs)
Warning: mounting bolts must point in fore-aft direction.
Do not mount bracket bolts in up-down or left-right direction.