Product Manual

Page of 8
6
Unloading Motorcycle
WARNING: Keep away from motorcycle parts that may suddenly move as tension is
released.
1. Remove Wing nut (10), Press Plate (9) and Ramp (2).
2. Hook Ramp (2) to lip on LEFT side of platform. The Ramp must be properly secured to Platform.
3. Release motorcycle’s front wheel from Wheel Clamps (23).
4. Have an assistant support motorcycle while carefully
releasing tension on all tie-downs.
5. Remove both Wheel Lock Pins (8) and their R-pins
(6).
6. Set motorcycle into Neutral gear. With assistance, push
motorcycle off Ramp until rear wheel is halfway across
Platform (1). Have assistant support motorcycle.
7. Replace front Wheel Lock Pin (8) and its R-pin (6).
8. Push motorcycle down Ramp and off Carrier.
9. Replace all Pins to their positions for storage.
10. Return Ramp (2) to mounted position and secure with Wing nut (10) and Press Plate (9).
MAINTENANCE
• Maintain your Motorcycle Carrier. It is recommended that the general condition of any
Motorcycle Carrier be examined before it is used. Keep your Motorcycle Carrier in good repair by
adopting a program of conscientious repair and maintenance. If any abnormal vibrations or noise
occurs, have the problem corrected before further use. Have necessary repairs made by
qualified service personnel.
• 1. BEFORE EACH USE, inspect the general condition of the carrier. Check for loose screws,
misalignment or binding of moving parts, cracked or broken parts and any other condition
that may affect its safe operation.
• 2. AFTER USE, clean surfaces with clean cloth.