Product Manual

Page of 8
4
ASSEMBLY
1. Align the two Platforms (1) and connect by two Joint Brackets
(28), using four Bolts (24) and Lock Nuts (25) on each Joint Bracket
(28) to secure two Platform (1).
2. Attach the two Arc Bars (26) to both sides of the Platform (1),
using two Bolts (24) and Lock Nuts (25) on two end of each Arc Bar
(26) to secure it on the Platform (1).
3. Screw the two Bolts (27) into the bushing on the Joint Bracket (28) and tighten fully.
4. Attach the two Wheel Clamps (23) to the Platform (1), using two Bolts
(21) and Lock Nuts (22) each Clamp.
5. Remove all Bolts (11,12,20), Washers (14,18), Nuts (13,15,19), Pins
(5,7) and Brackets (4,17) from Tube (3), as shown in photo #3.
6. Insert Tube into Platform (1) and secure with two Bolts (12), Washers
(14), and Nuts (13).
7. Attach Tie Down Brackets (4) to Tube with Bolt (11) and Nut (15).
8. Insert Tube into Class III (or better) 2in. receiver of a vehicle and lock it
with Hitch Pin (5). Insert R-Pin (7) through hole in Hitch Pin to hold it
in place.
9. Attach Stabilizers (17) to Tube using Bolt (20), Washer (18), and Nut
(19).
Tighten Stabilizers in place to reduce vibration of the Carrier.
REFER TO ABOVE PHOTO FOR
STEP
S
1, 2 and 3
PHOTO #2
PHOTO #3