49IN. ALUMINUM CARGO CARRIER OWNER’S MANUAL WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
Thank you very much for choosing a Ultra-Tow product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. This cargo carrier is designed for certain applications only. The distributor cannot be responsible for issues arising from modification.
IMPORTANT SAFETY CONSIDERATIONS CARGO CARRIER USE AND CARE Do not modify the cargo carrier in any way. Unauthorized modification may impair the function and/or safety and could affect the life of the equipment. There are specific applications for which the cargo carrier was designed. Always check of damaged or worn out parts before using the cargo carrier. Broken parts will affect the cargo carrier operation. Replace or repair damaged or worn parts immediately. Store idle cargo carrier.
Step 2 Align holes on red plastic hinges on the front, back and both side frames, insert M10 cup-head hex bolts (7) in, screw M10 locknuts (8) on for positioning, also install M10 bolts and locknuts on the 4 corners of the base, and tighten all. See FIG. 2 FIG. 2 7 8 Reflectors Step 3 Put above assembled carrier on 2” support tube (12), and tighten with M8 cup-head hex bolt (9), M8 flat washer (10), and M8 locknut (11). See FIG. 3. FIG.
OPERATION IMPORTANT: 2 adjustments are recommended for attaching the cargo carrier to the towing vehicle. Lift the Cargo Carrier and place the support tube into the towing vehicle’s 2in. hitch receiver. Line up the holes in the support tube with the hole in your receiver hitch. Then slide Hitch Pin through the holes and insert clip to secure the Hitch Pin. MAINTENANCE • Maintain your cargo carrier. It is recommended that the general condition of any cargo carrier be examined before it is used.
DIAGRAM AND PARTS LIST Part# Description Q’ty Part# Description Q’ty 1 Side Panels 2 8 M10 Locknut 8 2 Base 1 9 M8 Cup-head Hex Bolt 4 3 Back Panel 1 10 M8 Flat Washer 4 4 M4 Locknut 16 11 M8 Locknut 4 5 M4 Hex Bolt 16 12 2” Support Tube 1 6 Front Panel 1 13 7 M10 Cup-head Hex Bolt 8 14 Page 6 of 7 Hitch pin Clip 1 1
For replacement parts and technical questions, please call 1-800-222-5381. WARRANTY One-year limited warranty Distributed by Northern Tool + Equipment Co., Inc. Burnsville, Minnesota 55306 NorthernTool.
