Product Manual

Page 8 of 11
Maintenance
⚠WARNING
 When any malfunction occurs, stop using and repair it immediately as soon as possible.
 Inspect and operate this product regularly to confirm its proper operation and mounting condition.
 Use only soap and water to clean the outer lens. Use of other chemicals could result in premature
lens cracking (crazing) and discoloration. Lenses in this condition have significantly reduced
effectiveness and should be replaced immediately.
 Inspect and operate this product regularly to confirm its proper operation and mounting condition.
 Do not use a pressure to clean this product.
Maintain the product by adopting a program of conscientious repair and maintenance in accordance
with the following recommended procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep your tool in good repair. Keep handles dry, clean, and free from
oil and grease. The following chart is based on a normal operation schedule.
Maintenance Interval
Maintenance Point
Before Use
Clean the mounting surface and dry it thoroughly before
installation.
After Use
Inspect and operate this product regularly to confirm its proper
operation and mounting condition.
Troubleshooting
Use the table below to troubleshoot problems before contacting service personnel or your local
dealer. If the problem continues after troubleshooting, call your local dealer for assistance.
Failure
Possible Cause
Corrective Action
Beacon fails to
work when
connected.
Fuse inside the plug is broken.
Change the fuse with a 5-Amp fuse.
Beacon bulb is broken.
Change the halogen bulb.