Product Manual
Page 7 of 11
of dirt, grease and debris.
• Locate the desired location where you wish to mount the beacon. For best results you should
make sure the lens is unobstructed, so that the light can be seen 360 degrees.
• If you need to move the beacon, hold one side securely, then lift the other side of the beacon
from the room and move; repeat procedure to move the other side.
Before Each Use
⚠WARNING
Clean the mounting surface and dry it thoroughly before installation.
Always check damaged or worn out parts before using the light. Broken parts will affect the light’s
operation. Replace or repair damaged or worn parts immediately.
Operating Instructions
⚠WARNING
The vehicle should never be driven at high speeds while the light is mounted.
Do not install this product or route any wires in the deployment area of your air bag. Equipment
mounted or located in the air bag deployment area will damage or reduce the effectiveness of the
air bag, or become a projectile that could cause serious personal injury or death. Refer to your
vehicle owner’s manual for the air bag deployment area. The User/Installer assumes full
responsibility to determine proper mounting location, ensuring safety to all passengers inside the
vehicle.
It is strongly recommended to only plug 12V plug into 12V power port, as DC outlets can become
contaminated and not create a good connection.
Do not modify the beacon in any way. Unauthorized modification may impair the function and/or
safety and could affect the life of the product.
Do not attempt to activate or control this device in a hazardous driving situation.
Do not stare directly into these lights. Momentary blindness and/or eye damage could result.
• To turn on the beacon, insert the 12V plug into the vehicles power outlet. Press the on/off button
on the back on the 12V plug. When the beacon is operating, the LED on the plug’s switch will
illuminate.
• To turn off the beacon, remove the 12V plug from the vehicle’s power socket or position the
on/off switch to off.
AfterEach Use
⚠WARNING
Inspect and operate this product regularly to confirm its proper operation and mounting condition.
Unplug and dismount light after use.