Product Manual
Page 6 of 11
the tool itself.
Specific Operation Warnings
⚠WARNING
The vehicle should never be driven at high speeds while the light is mounted.
Do not install this product or route any wires in the deployment area of your air bag. Equipment
mounted or located in the air bag deployment area will damage or reduce the effectiveness of the
air bag, or become a projectile that could cause serious personal injury or death. Refer to your
vehicle owner’s manual for the air bag deployment area. The User/Installer assumes full
responsibility to determine proper mounting location, ensuring safety to all passengers inside the
vehicle.
It is strongly recommended to only plug 12V plug into 12V power port, as DC outlets can become
contaminated and not create a good connection.
Do not modify the beacon in any way. Unauthorized modification may impair the function and/or
safety and could affect the life of the product.
Do not attempt to activate or control this device in a hazardous driving situation.
Do not stare directly into these lights. Momentary blindness and/or eye damage could result.
Use only soap and water to clean the outer lens. Use of other chemicals could result in premature
lens cracking (crazing) and discoloration. Lenses in this condition have significantly reduced
effectiveness and should be replaced immediately.
Inspect and operate this product regularly to confirm its proper operation and mounting condition.
Do not use a pressure to clean this product.
Main Parts of Light
Reference
Subassembly
1
Warning Light Body
2
Cord
3
Plug
Assembly Instructions
⚠WARNING
The magnetic beacon should be positioned on the vehicle’s roof where the magnets will safely
secure the beacon.
Before mount the beacon to the roof, be sure the surface is clean and clear of dirt, grease and
debris.
Magnetic Mounting
• The magnetic beacon should be positioned on the vehicle’s roof where the magnets will safely
secure the beacon. Before mount the beacon to the roof, be sure the surface is clean and clear