2 Volt Flashing Halogen Warning Light Owner’s Manual e WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
Thank you very much for choosing an Ironton™ product! For future reference, please complete the owner’s record below: Serial Number/LotDate Code: ________________________________ Purchase Date: ____________________________________________ Save the receipt, warranty, and this manual. It is important that you read the entire manual to become familiar with this product before you begin using it. This light is designed for certain applications only.
Table of Contents Intended Use .......................................................................................................................................... 4 Technical Specifications ...................................................................................................................... 4 Important Safety Information ............................................................................................................... 4 Specific Operation Warnings .......................
Intended Use The Ironton 12 Volt Flashing Halogen Warning Light provides superior light in any conditions with 80 flashes per minute. Technical Specifications Property Bulb Type Volts Watt Bulbs (qty.) Power cord (ft.) Product Size Specification LED DC 12V 35 Watt 1 15 ft 5in. L x 5in. W x 3.4in. H Important Safety Information ⚠WARNING Read and understand all instructions. Failure to follow all instructions may result in serious injury or property damage.
Do not allow the product to come into contact with an electrical source. The tool is not insulated and contact will cause electrical shock. Keep children and bystanders away from the work area while operating the tool. Do not allow children to handle the product. Be aware of all power lines, electrical circuits, water pipes, and other mechanical hazards in your work area. Some of these hazards may be hidden from your view and may cause personal injury and/or property damage if contacted.
the tool itself. Specific Operation Warnings ⚠WARNING The vehicle should never be driven at high speeds while the light is mounted. Do not install this product or route any wires in the deployment area of your air bag. Equipment mounted or located in the air bag deployment area will damage or reduce the effectiveness of the air bag, or become a projectile that could cause serious personal injury or death. Refer to your vehicle owner’s manual for the air bag deployment area.
• • of dirt, grease and debris. Locate the desired location where you wish to mount the beacon. For best results you should make sure the lens is unobstructed, so that the light can be seen 360 degrees. If you need to move the beacon, hold one side securely, then lift the other side of the beacon from the room and move; repeat procedure to move the other side. Before Each Use ⚠WARNING Clean the mounting surface and dry it thoroughly before installation.
Maintenance ⚠WARNING When any malfunction occurs, stop using and repair it immediately as soon as possible. Inspect and operate this product regularly to confirm its proper operation and mounting condition. Use only soap and water to clean the outer lens. Use of other chemicals could result in premature lens cracking (crazing) and discoloration. Lenses in this condition have significantly reduced effectiveness and should be replaced immediately.
Parts Diagram Parts List Reference 1 2 3 4 5 Part Number Light Cover Light Bulb Cord DC Power Adaptor Magnetic Mount Base Quantity 1 1 1 1 1 Replacement Parts For replacement parts and technical questions, please call Customer Service at 1-800-222-5381. Not all product components are available for replacement. The illustrations provided are a convenient reference to the location and position of parts in the assembly sequence.
Limited Warranty Northern Tool and Equipment Company, Inc. ("We'' or ''Us'') warrants to the original purchaser only (''You'' or ''Your'') that the Ironton product purchased will be free from material defects in both materials and workmanship, normal wear and tear excepted, for a period of 90 days from date of purchase. The foregoing warranty is valid only if the installation and use of the product is strictly in accordance with product instructions.
Distributed by: Northern Tool & Equipment Company, Inc. Burnsville, Minnesota 55306 www.northerntool.com Made in China.
