Product Manual

Page 4 of 11
Intended Use
This 15 ton capacity Ultra-Tow XTP Series Auto-Locking Pintle Hook features a single-piece, cast
ductile iron with an upper steel lock that is designed for a flat, rigid mount. No adapter is needed. To
be used with a 2" to 3" I.D. drawbar eye ring with a 1-1/4" to 1-5/8" diameter cross section.
Technical Specifications
Property
Max. Gross Trailer Weight
Max. Vertical Load
Product Weight
Total Length
Material
Flat Mount Spacing
Important Safety Information
WARNING
Read and understand all instructions. Failure to follow all instructions may result in serious injury
or property damage.
The warnings, cautions, and instructions in this manual cannot cover all possible conditions or
situations that could occur. Exercise common sense and caution when using this pintle hook.
Always be aware of the environment and ensure that the tool is used in a safe and responsible
manner.
Do not allow persons to operate or assemble the pintle hook until they have read this manual and
have developed a thorough understanding of how it works.
Do not modify this pintle hook in any way. Unauthorized modification may impair the function
and/or safety and could affect the life of the product. There are specific applications for which the
product was designed.
Use the right tool for the job. DO NOT attempt to force small equipment to do the work of larger
industrial equipment. There are certain applications for which this equipment was designed. This
product will be safer and do a better job at the capacity for which it was intended. DO NOT use
this equipment for a purpose for which it was not intended.
Industrial or commercial applications must follow OSHA requirements.
WARNING
This product may contain chemicals known to the State of California to cause cancer, birth defects,
or other reproductive harm.
WARNING
WORK AREA SAFETY
Inspect the work area before each use. Keep work area clean, dry, free of clutter, and well lit.