Product Manual

Page 6 of 14
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
Specific Operation Warnings
⚠WARNING
 To prevent serious injury or property damage, read and understand the owner’s manual.
 Do not exceed lowest rated load capacity in hitch system.
 Maintain adequate vertical down (tongue) load to have control of the trailer (generally 10%), but do
not exceed the specified rated capacities.
 Other steps and inspections are also required. Consult OSHA, D.O.T. regulations, and the
American Trucking Association for complete coupling and uncoupling procedures.
 Keep safety chains in place and in working order. Never operate the product without the safety
chains attached to vehicle.
Towing
⚠WARNING
Trailers and equipment are designed for on-road towing within the stated capacities. For off-road
applications, reduce the capacities listed in the specifications table by 25%, and use in conjunction
with a swivel-type drawbar.
Mounting
1. Use a secure mounting structure of sufficient strength to support the rated capacity of the hitch in
accordance with SAE J 849B.
2. The hitch receiver on the vehicle needs to have a 2'' square tubing inside.
3. Insert the hitch assembly into the receiver of the vehicle. Then insert a 5/8'' diameter bolt or pin
through the cross hole in the receiver using a lock nut or locking pin to secure the bolt or hitch pin
(not included). See the image below.