Product Manual

Page 8 of 12
Locked Position
The illustration above is in the locked position with the safety clip installed. Insure the lock assembly is
in the unlock position before hooking up.
Un-Hitching
1. Unlock by removing the safety pin. Secondary Lock
2. Flip the secondary lock forward until it is pointing up.
Now you can jack-up the coupler until it clears the hitch ball. The unit is back to the unlock position, as
shown in the illustration above.
Maintenance
For proper performance, the following should be performed every 10,000 miles or 6 months,
whichever comes first.
Maintain the product by adopting a program of conscientious repair and maintenance in accordance
with the following recommended procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep your tool in good repair. Keep all cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to
control. Keep handles dry, clean, and free from oil and grease. The following chart is based on a
normal operation schedule.