Installation manual

G:\InDATA\manuals\OM-KE E V1.02 August 17, 2012
Page 17
KING KE 1107
INSTALLATION INSTRUCTIONS cont.
MOBILE HOME (AND RESIDENTIAL ALCOVE INSTALLATIONS)
Either Rear Shield OR Fan kit are required for these installations (See next page for kits and part
numbers). Mobile home installations also requires the Outside Air Kit: Z1726B. ey are easiest
to mount before the stove is installed. See instructions packed with each kit.
When a metal prefabricated chimney is used, the manufacturer’s installation instructions must be
followed precisely. You must also purchase (from the same manufacturer) and install the ceiling
support package, re stops (when needed), insulation shield, roof ashing, chimney cap, etc.
Maintain the proper clearance to the structure as recommended by the manufacturer.
Chimney connector must be double wall close clearance type, and must be of same brand and
model as listed prefabricated chimney. Single wall pipe is not allowed in Mobile Homes or in
Alcove Installations. Insulated chimney components must be a listed factory built chimney
suitable for use with solid fuels and conforming to, ULC629 in Canada or UL-103HT in the USA.
For Mobile home, the chimney need to be removable to allow for transportation of the mobile
home.
MOBILE HOME:
WARNING - DO NOT INSTALL IN SLEEPING ROOM
CAUTION - THE STRUCTURAL INTEGRITY OF THE MOBILE HOME
FLOOR, WALL ANDCEILING/ROOF MUST BE MAINTAINED.
In mobile home installations, the stove must be securely fastened to the oor using the tie-
downs provided in the Outside Air kit. (For the pedestal model, remove the ash drawer to
access the screw down holes. For the Leg model, use the Leg Anchor Kit (P/N ZR8039) to secure
stove to oor.)
ALSO, a #8 ground wire must be attached to the stove and an appropriate ground.