- Applicated Security Technologies Remote Starter User Manual

PAGE 16
72 SERIES
OWNER'S MANUAL
LED 2 WAY
LED 2 WAY SYSTEMS
PANIC MODE
When the lock button is held for 5 seconds the system will enter Panic Mode.
The LEDs under the buttons will flash in a pattern and the remote will beep to
indicate Panic Mode is active. If the system is not in range the remote will
beep 3 times.
LOCK
UNLOCK
TRUNK RELEASE
When the unlock button is held the light behind the button will flash twice and
the remote will beep twice after 3 seconds the remote with beep again as
confirmation that the function has been completed. If the system is not in
range the remote will beep 3 times.
LOW
BATTERY
LOW BATTERY WARNING
When the battery voltage is low all of the LEDs behind the buttons will
activate at the same time and the remote will beeps once immediately when
a button is pressed. Range and features such as Panic Mode and Trunk
Release may not function when the batteries are low.
HOLD
HOLD
COLD START MODE (See page 13 for more details)
1- Press and release the # button then within 3 seconds hold the start button for 8 seconds.
2- All 4 LEDs on the remote will illuminate to indicate that the start cycle selection. Within 3
seconds select the start cycle
a. Press Unlock for 2hr timer. LEDs will flash twice as confirmation.
b. Press Start for 3hr timer. LEDs will flash three times as confirmation.
c. Press # for 4hr timer. LEDs will flash four times as confirmation.
PRESS AND
RELEASE
PRESS AND
HOLD
THEN
HOLD 8 SEC.
PAGE 17
OWNER'S MANUAL
TROUBLE SHOOTING
72 SERIES
Vehicle is not remote
starting?
- Count the park light flashes then see the diagnostics page.
- Check battery voltage in the remote.
- Make sure you are with-in operating range.
- Check if the vehicle anti-theft is activating.
- Reprogram the remote’s using Transmitter Program Mode.
Doors do not lock
Or unlock
- Was this optional feature installed?
- Have your installer check the door lock connector.
- Have bypass or keyless module reprogrammed.
SYMPTOM CAUSE/SOLUTION
Horn does not honk
- Was this optional feature installed?
- Try panic mode to see if horn activates. If not,
have the systems horn output checked.
Vehicle starts then shuts
off by itself
- Check if the vehicle anti-theft is activating.
- Is the starter motor staying on to log? If so,
reprogram the tach and try again.
- See dealer if problem is not resolved.
Lights on the antenna
are flashing
- When the doors are locked by the remote the LEDs will flash until the
unlock button is pressed.
- If you do not want the LEDs to flash have your installer program the
LED flashes off.
The system does not
respond to the remote
transmitter
- Try your second remote.
- Check the batteries in the remote.
Reprogram the remote’s using Transmitter Program Mode.
- Make sure you are with-in operating range.
We recommend that you contact your dealer if you encounter a problem with your system. If your
dealer is not available, see to locate an Authorized
Dealer in your area. For more advanced trouble shooting tips, programming videos, programming
PDF’s and FAQ’s please visit
http://ultrastarters.com/dealer_locator.html
www.ultrastarters.com/support.html
PLEASE NOTE