- Applicated Security Technologies Remote Starter User Manual

PAGE 12
72 SERIES
OWNER'S MANUAL
OVERRIDE MODE
This feature is to be used if the remote transmitter is lost or is not communicating with
the system. This will disable the optional starter disable if installed. Follow the steps
below to deactivate your system.
EMERGENCY OVERRIDE MODE
ACTIVATING EMERGENCY OVERRIDE MODE
Turn the Ignition Key ON
(Leave in the ON position)
Press and hold the Valet switch for 8 to 15 seconds
(Time depends on "Valet Settings" Program Option)
The horn will honk 5 times as confirmation that the system is
now in Emergency Override Mode.
DEACTIVATING EMERGENCY OVERRIDE MODE
Turn the Ignition Key ON
(Leave in the ON position)
Press and hold the Valet switch for 8 to 15 seconds
(Time depends on "Valet Settings" Program Option)
The horn will honk 2 times as confirmation that the system is
has exited Emergency Override Mode.
PAGE 13
72 SERIES
OWNER'S MANUAL
COLD START MODE
Code Start Mode will start the vehicle at a user selectable start interval. The vehicle
can be set to start once every 2, 3 or 4 hours, for a maximum of 12 starts. The
vehicle will start at the selected start interval and run for the programmed runtime*.
EXAMPLE: If the 4 hour start cycle was selected, the vehicle will start once every 4
hours and run for the programmed runtime*.
Method 1- Press and release the button, then press and hold the button for 6
seconds or until park lights turn on. Use on 2way Models.
Method 2 - Press the and buttons at the same time for 3 seconds or until the
park lights will turn on.
While the park lights are on the start cycle may be selected. See below:
2 hours Press and release the button 2 Park light flashes
3 hours Press and release the button 3 Park light flashes
4 hours Press and release the button 4 Park light flashes
NOTE: Timer Mode must be set each time the user wishes to use this feature.
To Cancel Cold Start Mode
Timer Mode will automatically turn off after 24 hrs or you may use one of the
following methods to manually disable Timer Mode. Cancellation will be confirmed
with 2 park light flashes and 2 horn Honks.
Method 1- Press and release the button, then press and hold the button for 6
seconds.
Method 2- Press the and buttons at the same time for 3 seconds.
NOTE: Pressing the brake pedal or turning the ignition to the ON position will cancel
Cold Start Mode.
SETTING COLD START MODE
Note- The 1172 can only control features related to the Unlock and Start buttons.