User manual

Digital Projection Titan Pro Series 3 USING THE PROJECTOR Operating Guide
84Rev F July 2014
Network
This menu allows setup of two networks, Control (via the RS232 port) and LAN (via the LAN port).
Control
• Set DHCP to On if the IP Address is to be assigned by a DHCP server, or Off if it is to be set
here.
• If DHCP is set to On, it will not be possible to edit either IP Address or Subnet.
• If DHCP is set to Off:
1. Edit IP Address and Subnet as required.
2. Power cycle the projector in order for the new settings to take effect.
The MAC Address of the projector is shown at the bottom of the screen.
LAN
• Set DHCP to On if the IP Address is to be assigned by a DHCP server, or Off if it is to be set
here.
• If DHCP is set to On, it will not be possible to edit either IP Address or Subnet.
• If DHCP is set to Off:
1. Edit IP Address and Subnet as required.
2. Select Apply Settings and press OK.
The elds at the bottom of the menu show the current settings.
Notes
Main Menu
Setup
Network
Any new settings will not be effective
until the projector has been power
cycled.
If the rst digit of an address octet is
set to “2”, then it will not be possible
to enter values above 5 for the
second or third digits. To overcome
this, set the rst digit to either “0” or
“1”. You can set the rst digit back to
“2” later if necessary.
Main Menu
Setup
Network
Control
Main Menu
Setup
Network
LAN