User manual
Digital Projection Titan Pro Series 3 SIGNAL INPUTS AND OUTPUTS Connection Guide
24Rev F July 2014
Rear connection panel continued
6
Composite 1 (CVBS 1) (input 5)
Uses a BNC connector to receive composite video.
7
S-Video (input 6)
Uses a 4-pin mini-DIN connector.
8
Component (input 7)
Uses either RGsB/RGSB, or YPbPr.
When using RGsB or RGBS:
• Set Component Colour Space in the Setup/Input Conguration menu to
RGB.
• Set Component Sync Type in the Setup/Input Conguration menu to Auto,
except when the projector has problems selecting between 3 Wire (RGsB) and
4 Wire (RGBS).
When using YPbPr:
• Set Component Colour Space in the Setup/Input Conguration menu to
YPbPr.
9
Composite 2 (CVBS 2) (input 8)
Uses an RCA phono connector to receive composite video.
Notes
For a complete listing of pin
congurations for all signal and
control connectors, see Appendix
E: Wiring Details the Reference
Guide.
See Side connection panel on
3D projectors and Differences
between Inputs 9-11 and Inputs
1-8 further in this section for more
information about input connections
and the differences between the two
connection panels.
Rear Connection Panel
8
6
7
9