User manual

ManualsBrandsUltra Start ManualsAutomobile Alarm660 Series

Digital Projection Titan Pro Series 3 SIGNAL INPUTS AND OUTPUTS Connection Guide

23Rev F July 2014

Signal Inputs and Outputs

Inputs 1-8, on the rear of the projector, are limited input frame rates up to 60Hz, but provide

access to the full geometric adjustment capabilities, including Blend and Warp.

The side inputs 9, 10 and 11 on 3D projectors provide a very direct path to the DMD™ display,

with minimal latency and high frame rate capability. Their geometrical adjustment capabilities are

limited in comparison with inputs 1-8.

Rear connection panel

VGA (input 1)

Receives analog signal from a computer. When using this input, it is best to use a fully

wired VGA cable (with a blue connector shell) to connect the source to the projector.

This will allow the source to determine the projector’s capabilities via DDC and show

an optimized image.

Use Auto Setup in the Image/VGA Setup menu.

HDMI (input 2)

Receives digital signal from HDMI-compliant devices. The audio from the HDMI source

is available on the SPDIF output.

SPDIF

Compatible audio sample packets on the HDMI input stream are decoded by the

projector and output on the SPDIF connector. This is a digital output.

DVI (input 3)

Analog or Digital DVI-I

This input has a DVI-I connector, which can receive either analog (DVI-A) or digital

(DVI-D) signal from a compatible source.

Set DVI-I Port in the Setup/Input Conguration menu to choose between Analog

and Digital.

Sources up to:

• 1920x1080 resolution for 1080p models

• 1920x1200 resolution for WUXGA models

24-60Hz; up to 12 bits per color. Supports HDCP.

3G-SDI (input 4)

Uses a BNC connector to receive uncompressed, unencrypted digital video.

If two video streams are being transmitted, set 3G Level B Stream in the Setup/Input

Conguration menu to choose between the two streams.

(the list continues overleaf)

Notes

For more VGA settings, see Image

menu in the Operating Guide.

For further information on setting

up the DVI 1 input, see Input

Configuration in the Operating

Guide.

For a complete listing of pin

congurations for all signal and

control connectors, see Wiring

Details in the Reference Guide.

See Side connection panel on

3D projectors and Differences

between Inputs 9-11 and Inputs

1-8 further in this section for more

information about input connections

and the differences between the two

connection panels.

Rear Connection Panel