User manual

Digital Projection Titan Pro Series 3 OPERATING THE PROJECTOR Installation and Quick-Start Guide
16Rev F July 2014
Operating The Projector
Switching the projector on
1. Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
2. Wait until the self-test has completed and the standby indicator on the projector control panel shows amber. The lamp will be off and the
projector will be in STANDBY mode.
3. Press ON on the remote control or the control panel and hold for three seconds, to switch the projector ON. The power indicator on the
control panel will show green, the lamp will light and the shutter will open.
Switching the projector off
1. Press OFF on the remote control or the control panel, and hold for three seconds. The power indicator on the control panel will show
amber, the lamp will go out and the cooling fans will run for a short time until the projector enters STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the power connector and then disconnect
the power cable from the projector.
Notes
The self-test is running when all the
LEDs on the control panel are lit.
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Always allow the lamp to cool for
ve minutes before:
- disconnecting the power
- moving the projector