User manual

Digital Projection Titan Pro Series 3 POSITIONING THE SCREEN AND PROJECTOR Installation and Quick-Start Guide
14Rev F July 2014
Fitting the optional rigging frame
1. Remove the four adjustable feet.
2. Secure the rigging frame to the projector, as shown, making
sure that the male frame couplings are at the top. Secure
each adaptor plate to the projector (three screws), and secure
each of the adjuster brackets to an adaptor plate (three
screws).
Stacking projectors
The projectors can be stacked on top of each other, or suspended
below each other.
1. Carefully lower each projector down onto the top of the
others, making sure that all four frame couplings engage fully.
2. Fit a locking pin into each coupling. A ball in the end of the
pin prevents the pin from falling out – to insert or remove a
locking pin, press the button on the end of the pin to release
the ball.
1
Vertical adjusters
2
Horizontal adjuster
3
Frame couplings
4
Fixing screws (2x3)
5
Locking pin
Pitch, roll and yaw
• To adjust the pitch, turn either the front pair or the rear pair of
vertical adjusters, taking care to turn both adjusters by the same
amount.
• To adjust the roll, turn either the left pair or the right pair of vertical
adjusters, taking care to turn both adjusters by the same amount.
• To adjust the yaw, turn the single horizontal adjuster at the front.
2
5
1
3
4
Notes
Always allow the lamp to cool for
ve minutes before:
- disconnecting the power
- moving the projector
Do not place the projector with its
front panel down on a surface, as
this may damage the lens or the
lens release lever.
Do not stack more than three
projectors.
Do not place heavy objects on top
of the projector chassis. Only the
chassis corners and the rigging
frame are capable of withstanding
the weight of another projector.
Backup safety chains or wires
should always be used with
ceiling mount installations.
Pitch Roll Yaw