User manual

Digital Projection Titan Pro Series 3 POSITIONING THE SCREEN AND PROJECTOR Installation and Quick-Start Guide
13Rev F July 2014
Positioning The Screen And Projector
1. Install the screen, ensuring that it is in the best position for viewing by your audience.
2. Position the projector, ensuring that it is at a suitable distance from the screen for the image to ll the screen.
Tilting the projector
Do not tilt the projector more than is shown in the tilt diagrams, when in use, as this may cause serious lamp failure, damage the
lamp module and cause extra cost on replacement.
Chassis adjustment
If the projector is to be operated from a at surface such as a projector table, adjust the projector level by turning the four feet under the
chassis. Set the adjustable feet so that the projector is level, and perpendicular to the sceen.
SX+ 330-P
1080p 330-P
WUXGA
330-P
TITAN 330
Ceiling (inverted)
SX+ 660
1080p 660
WUXGA 660
180°
±10°
±10° ±10°
±10°
180°
TITAN 660
Desktop
SX+ 660
1080p 660
WUXGA 660
SX+ 330-L
1080p 330-L
WUXGA
330-L
Notes
Always allow the lamp to cool for
ve minutes before:
- disconnecting the power
- moving the projector
Ensure that there is at least
30 cm (12 in.) of space between
the ventilation outlets and any
wall, and 10 cm (4 in.) on all other
sides.
Do not place the projector with its
front panel down on a surface, as
this may damage the lens or the
lens release lever.
±10°
±10°