Install guide

Wiring Descriptions
MAIN CONNECTOR (6pin)
Pin Function Description
1-YELLOW Starter Output - This wire will test 0V in OFF, ACCESSORY and in the
ON key positions. 12v during START ONLY.
2-GREEN Heater/Acc Output - This wire will test 0V in the OFF and START key
positions. 12-14V in the ACCESSORY key position.
3-RED 12volt Input(30amp) - Supplies 12votls for the IGNITION, PARK
LIGHT and SELECTABLE outputs.
4-RED 12volt Input(30amp) - Supplies 12 volts for ACCESSORY and
STARTER outputs.
5-BLUE Ignition Output - This wire will test 0V in the OFF and ACCESSORY
key positions.12V in the IGNITION and START.
6-WHITE Selectable Output - Output for 2nd IGNITION, 2nd ACCESSORY
or 2nd STARTER.
AUXILIARY CONNECTOR (14pin)
Pin Function Description
1-YELLOW Re-arm(-) - 0.75 second pulse output when is pressed and after
remote start shutdown. Used for factory alarm re-arm.(menu 3)
2-ORANGE Anti-Grind/ (-) - Output active during remote start. Programmable Starter
Starter Kill Kill output. (Menu 3)
3-BROWN Dis-arm(-) - 0.75 second pulse when is pressed and before remote
starter activation. Used for factory alarm dis-arm. (Menu 3)
4-RED/ Trunk Release(-) - Programmable output. Hold or button for 3 secs
WHITE output will stay active (max 5 seconds) or (-)park light.
5-WHITE/ Ground While Running(-) - 250ma ground output while remote starter
VIOLET is activated.
6-GREEN Door Pin(-) - Input to detect (-) when door is open.
7-GREEN/ Hood Pin(-) - Input to detect ground when hood is open.
WHITE MUST BE CONNECTED.
8-PURPLE Door Pin(+) - Input to detect 12v when door is open.
9-PINK Brake Light (+) - Positive brake light switch input. Used to detect the
brake switch being applied.
10-BLACK Ground(-) - System chassis ground input.
11-BLUE/ Tach(A/C) - A/C Tach signal input. Used to detect engine speed to indicate
WHITE vehicle is running.(Coil, Injector, cam/crank position sensors)
12-BLUE Diesel(+/-) - Programmable Wait to Start Input. Detects 12v or
negative signals.(menu 3)
INSTALL MANUAL REMOTE VEHICLE STARTER
PAGE 8