Technical information

562600-000, Issue1.0, March 2014
42 of 57
9.4 LED and Internal Alarm Warnings
The table below shows the state of the three LEDs on the display and the internal alarm
with respect to system status.
10 Daily Checks
See section 12 for test / diagnosis features. If an issue is discovered which
cannot be rectified using this guide, halt any operation, seek authorised ser-
vice immediately and do not continue operation until the fault has been reme-
died.
 Display - check for damage and correct operational
 Safety Controller - check for damage and correct operational
 Sensors and sensor cabling - check for damage
 Connectors - check for damage
 Alarm / Blue Lamp / Amber Lamp functionality
 Automatic Duty Selection
 Relays inputs and motion cuts
 Check Anti Tamper devices are secure on motion cut valves and master override
keyswitch
11 Repair
Once a repair has been carried out and tested, the following must be
checked:
Required Checks Section
Angle Sensor Check 12.2
Relays Check 12.1
Alarm, LED and Beacons Check 12.3
Maintenance review 17.1
LED and Internal Alarm status System status
Off
Start up, Power Down
Operational: System OK, no warnings, hazards, or errors
Warning: Approach to overload or envelope limit
Hazard; Overload or breach of an envelope limit
Maintenance: Engineering access active
Error: PME hardware/software error, or sensor failure
1 Hz
Continuous
8 Hz