Technical information

562600-000, Issue1.0, March 2014
39 of 57
9 System Messages
9.1 On Screen Safety Messages
*The approach limit is configurable at point of calibration, check system operation before
Approaching max height
Highest point of equipment within *0.5m of set limit
Maximum height exceeded
Equipment has reached/exceeded set limit
ALO Controlling Slew
PMERail is controlling slew movement toward the
slew limit
Approaching Slew limit
Equipment within *10 degrees or 0.5m of set limit
Slew Limit exceeded
Equipment has reached/exceeded set limit
Max Boom Angle Exceeded
Boom has reached/exceeded a set value
Lifting barred in next Duty
Insufficient lifting capacity in next duty
Lifting barred in this Duty
Cannot lift in this duty
Maximum working cant exceeded
Track cant exceeded limit (default = 180mm).
Maximum working gradient ex-
ceeded
Track gradient exceeded limit (default = 1 in 30).
Approaching canted duty
Insufficient lifting capacity in next duty
(Lift and carry duties only) No motion cut will occur
Fully Extend/Retract Counter-
weight
Fully extend/retract counterweight
Offset boom is not straight
Offset boom not straight. System will automatically
cancel any slew limit set, warning message must be
acknowledged
Approaching SWL
95 percent of the maximum safe working load
Overload
105 percent of the maximum safe working load
Hydraulic Limit
Pressure in a ram/s is in excess of 87% of main relief
valve pressure
In Override
Override has been activated (Soft override or master
Key)
In Gauge Lock Active
In Gauge mode has been activated