Technical information

562600-000, Issue1.0, March 2014
19 of 57
7.7.2 Lifting Mode - Non Lifting Mode
When the machine is not being used for lifting op-
erations it can be put into ‘Non Lifting Mode’. This is
available from the Lifting Mode screen.
When in Non Lifting Mode, the system still monitors
all machine activity and safety status but will NOT
warn of overload or impose any form of overload hydraulic control, the system will con-
tinue to monitor back stability conditions.
In this mode, the blue lamp will be off, indicating that the Lifting Mode functionality is NOT
active. Non Lifting mode will auto exit if the rail bogie status changes. Envelope Limit
monitoring will remain active if any limit has been set.
The Supervisor keyswitch must be in the SET position to access this feature if it is en-
abled, see section 5.5 for further information.
Lifting mode cannot be deactivated if the LOH value exceeds a
predefined weight, press the GREEN TICK to acknowledge
and return to lifting mode.
When in Non Lifting Mode, the screen states NON-LIFTING MODE on the
hazard warning tape, lifting operations should not be attempted in this state.
The blue lamp will be off.
Moves highlighter UP
Moves highlighter DOWN
Accept highlighted
Non-lifting mode
Exit without change