Technical information

562620-000, Issue1.0, March 2014
18 of 25
14 System Messages
14.1 On Screen Safety Messages
*The approach limit is configurable at point of calibration, check system operation before
commencing work.
Close to max height
Highest point of equipment within *0.5m of set limit
Maximum height reached
Equipment has reached set limit
ALO Controlling Slew
PMERail is controlling slew movement toward the
slew limit
Close to Slew limit
Equipment within *10 degrees or 0.5m of set limit
Slew Limit reached
Equipment has reached set limit
Max Boom Angle reached
Boom has reached a maximum set angle
Lifting barred in next Duty
Insufficient lifting capacity in next duty
Lifting barred in this Duty
Cannot lift in this duty
Maximum working cant reached
Track cant reached limit (default = 150mm).
Maximum working gradient
reached
Track gradient reached limit (default = 1 in 25).
Close to canted duty
Insufficient lifting capacity in next duty
(Lift and carry duties only) No motion cut will occur
Fully Extend/Retract Counter-
weight
Fully extend/retract counterweight
Offset boom is not straight
Offset boom not straight.
Close to SWL
95 percent of the maximum safe working load
Overload
105 percent of the maximum safe working load
Hydraulic Limit
Pressure in a ram/s is in excess of 87% of main relief
valve pressure
In Override
Override has been activated (Soft override or master
Key)
In Gauge Lock Active
In Gauge mode has been activated