Instruction manual

Operation
Rotor management
2-64 WX Ultra Series Thermo Scientific
Thus the rotor has been registered.
Deleting a registered rotor
If a registered rotor becomes unnecessary, you can delete it from ultracentrifuge memory.
As an example, suppose that you need to delete the T-890 fixed angle rotor registered in the previous
section.
Note When the ENTER key is pressed in the above steps “7” to “9”, “0” is registered as a numeric
value in each step. When the serial number must be corrected, the rotor must be deleted once and
the value must be reentered from step “1”. (See the next page.)
In the steps “7” to “9”, it is possible to change the value repeatedly by moving the cursor with the
arrow keys unless the ENTER key is pressed.
Note Once a registered rotor is deleted, all of the life management data for the rotor will be lost.
Step Key operation Screen display and considerations
1 While in the Run Screen, use the cur-
sor keys to move the cursor to RLM
and press ENTER key.
2 Use cursor keys to move the cursor to
the T-890 line to be deleted and press
the ENTER key.
3 Select “Deleting” by pressing the fol-
lowing keys.
4 Select “Yes” by pressing the following
keys.
>> If you select “No”, you will get the display you see in process 2.
• The display switches to the
Rotor Management screen.