Instruction manual

Operation
Basic operation
Thermo Scientific WX Ultra Series 2-7
Operation procedure
1 Press cursor keys to enter the system into an
input wait state.
The system enters an
input wait state.
2 hours 30 minutes
2 Use cursor keys to move the cursor to the
status indicator. (The arrows indicate the
directions the cursor can be moved..
The system enters an
input wait state.
3 The cursor in the setting item field blinks for
about 30 seconds.
Blinking means that the system enters an
input wait state.
4 Use numeric keys to enter a setting.
Entered numbers are moved to the left every
time a new number is entered.
The last two digits are
fixed.
Press the “ ” key to
move the cursor to the
“minutes” position.
For a continuous run,
press HOLD/FREE.
5 Make a check, then press ENTER.
After pressing a cursor key, you can still
enter a setting similarly to the ENTER key.
Use CE to cancel an input.
Set it to 100,000 rpm. Set it to 2:30
(2 hours 30 minutes).
Setting range and units Can be set to any value in
the range from 1,000 rpm
to maximum speed in
increments of 100 rpm.
Can be set to any value
up to 99 hours 59 minutes
in increments of 1 min-
ute.
Arrow
Temperature (TEMP) Acceleration (ACCEL) Deceleration (DECEL)
4.5 °C 9 7
Enters an input wait state. Enters an input wait state. Enters an input wait state.