Instruction manual

Preinstallation
Moving the ultracentrifuge
Thermo Scientific WX Ultra Series 5-3
4. When the instrument is level, check that the four leveling screws are secured to the floor.
Figure 5-3 Level placement
Moving the ultracentrifuge
When moving the ultracentrifuge, disconnect the power cord and unscrew the leveling screws with a
wrench to lower the caster to the floor. Raise the leveling screws enough to remove the leveling pads,
then move the ultracentrifuge. After moving, be sure to install and level the instrument again.
Level
Drive shaft
CAUTION Before moving the ultracentrifuge, be sure to remove the rotor from the drive
shaft and store it in a safe place.