Automobile Alarm User Manual

Shock Sensor-Alarm series ONLY!
OWNER’S GUIDE PAGE 18
Adjusting the shock sensor:
While the park lights are “ON”, strike the vehicle with the amount of force
wanted to trigger the alarm.
NOTE: The siren will chirp 3 times each time the system detects impact.
Press and release to increase sensitivity (up to 10 chirps/ flashes).
Press and release to decrease sensitivity (down to 1 chirp/ flash).
NOTE: Be careful not to impact the vehicle in a area that may cause damage.
The most common location for testing and setting the shock sensor is
the vehicles A-pillar. The A-Pillar is the metal support that runs from the
roof of the vehicle to the hood area.
To enter shock sensor programming:
Press and hold the and the buttons for three seconds.
The park lights will flash and the siren will three times.
To exit and save shock sensor programming:
Press and hold the and the buttons, the siren will chirp and the park lights
will flash the number of times of the shock sensor impact level chosen.
Example: Level 5 = 5 Chirps/ 5 Park Light flashes
Shock Sensor Programming/ Adjustment
IMPORTANT SECURITY NOTES!
If the system has been triggered (shock sensor, door input..), the siren
will sound for approximately 60 seconds. Press and release the or
the button to silence the siren (the system will remain armed).
Press and hold the button to disarm the system. The siren and park
lights will flash three times to indicate the system had been triggered.