Specifications
CC1101 
      SWRS061I     Page 16 of 98
4.3  RF Transmit Section 
T
A
 = 25C, VDD = 3.0 V, +10 dBm if nothing else stated. All measurement results are obtained using the CC1101EM reference 
designs ([1] and [2]). 
Parameter 
Min 
Typ 
Max 
Unit 
Condition/Note 
Differential load 
impedance 
315 MHz 
433 MHz 
868/915 MHz 
122 + j31 
116 + j41 
86.5 + j43 
 
 
 
Differential impedance as seen from the RF-port (RF_P and 
RF_N) towards the antenna. Follow the CC1101EM reference 
designs ([1] and [2]) available from the TI website 
Output power, 
highest setting 
315 MHz 
433 MHz 
868 MHz 
915 MHz 
+10 
+10 
+12 
+11 
dBm 
dBm 
dBm 
dBm 
Output power is programmable, and full range is available in all 
frequency bands. Output power may be restricted by 
regulatory limits. 
See Design Note DN013 [15] for output power and harmonics 
figures when using multi-layer inductors. The output power is 
then typically +10 dBm when operating at 868/915 MHz. 
Delivered to a 50  single-ended load via CC1101EM 
reference designs ([1] and [2]) RF matching network 
Output power, lowest 
setting 
-30 
dBm 
Output power is programmable, and full range is available in all 
frequency bands 
Delivered to a 50 single-ended load via CC1101EM 
reference designs ([1] and [2]) RF matching network 
Harmonics, radiated 
2
nd 
Harm, 433 MHz 
3
rd
 Harm, 433 MHz 
2
nd 
Harm, 868 MHz 
3
rd
 Harm, 868 MHz 
2
nd 
Harm, 915 MHz 
3
rd
 Harm, 915 MHz 
-49 
-40 
-47 
-55 
-50 
-54 
dBm 
dBm 
dBm 
dBm 
dBm 
dBm 
Measured on CC1101EM reference designs ([1] and [2]) with 
CW, maximum output power 
The antennas used during the radiated measurements 
(SMAFF-433 from R.W. Badland and Nearson S331 868/915) 
play a part in attenuating the harmonics 
Note: All harmonics are below -41.2 dBm when operating in 
the 902 – 928 MHz band 
Harmonics, conducted 
315 MHz 
433 MHz 
868 MHz 
2
nd 
Harm 
other harmonics 
915 MHz 
2
nd 
Harm 
other harmonics 
< -35 
< -53 
-43 
< -45 
-36 
< -46 
-34 
< -50 
dBm 
dBm 
dBm 
dBm 
dBm 
dBm 
dBm 
dBm 
Measured with +10 dBm CW at 315 MHz and 433 MHz 
Frequencies below 960 MHz 
Frequencies above 960 MHz 
Frequencies below 1 GHz 
Frequencies above 1 GHz 
Measured with +12 dBm CW at 868 MHz 
Measured with +11 dBm CW at 915 MHz (requirement is -20 
dBc under FCC 15.247) 










