Instruction manual

Remote Station - Guide Point Adjust
90
Introduction
The Guide Point Adjust Remote Station provides a convenient method of adjusting the system’s
guide point from a remote location.
The Guide Point Adjust Remote Station is compatible with the following controllers:
MICRO 4000 NET or MICRO 1000 Controllers
The Guide Point Adjust Remote Station requires an interface cable to connect to these
controllers. Cables are available in standard lengths of 12’ [3.6m], 25’ [7.6m], 50’ [15.2
m], 75’ [22.8m], and 100’ [30.5m].
The Guide Point Adjust Remote Station also requires a Serial I/O board (AUX 4249) to
connect to the MICRO 1000 Controller.
Product Specifications:
• Remote Station size (H x W x D): 2.52” [64mm] x 3.86” [98mm] x 1.41” [36mm]
• Power requirements: Supplied by controller
• Operating environment:
Maximum ambient temperature 120 deg F [48.9 deg C]
Humidity 0-90%, Non-condensing
Installation
The Remote Station can be mounted in a variety of ways. The enclosure design allows the user
to easily remove the rear housing for panel-mount applications. Refer to the application drawings
and connection diagrams on page 139 for installation information.