Instruction manual

MICRO 4000
®
NET Controller
20
Input A Type
1 2 0
Sensor A is not installed.
1 2 1
Sensor A is an ultrasonic or IR edge detector connected to the Edge
Detector A input. This is the default setting.
Note: Set parameter 55 to select sensor type.
1 2 2
Sensor A is a digital line guide connected to the Serial I/O interface.
1 2 3
Sensor A is an external analog device connected to Analog Input 1.
Note: In order to select Input A through the front-panel switchpad, fieldbus or Discrete Isolated
Inputs, parameter 12 must be set to 1 or higher.
Input B Type
1 3 0
Sensor B is not installed. This is the default setting.
1 3 1
Sensor B is an ultrasonic or IR edge detector connected to the Edge
Detector B input.
Note: Set parameter 56 to select sensor type.
1 3 2
Sensor B is a digital line guide connected to the Serial I/O interface.
1 3 3
Sensor B is an external analog device and is connected to Analog Input
2.
Note: If parameter 2 is set to 1, then Analog Input 2 must be connected
to the actuator’s position-sensing potentiometer.
Note 1: In order to select Input B through the front-panel switchpad, fieldbus or Discrete Isolated
Inputs, parameter 13 must be set to 1 or higher.
Note 2: In order to select Centerline mode through the front-panel switchpad, fieldbus or Discrete
Isolated Inputs, parameters 12 and 13 must both be set to 1 or higher.
Edge Detector A Signal Level
1 4 a a. b b b
This parameter displays edge detector A’s signal levels. Digits aa display
the beam number and digits bbb display the signal level. Use the DAT
A
buttons to select the desired beam.
Edge Detector B Signal Level
1 5 a a. b b b
This parameter displays edge detector A’s signal levels. Digits aa display
the beam number and digits bbb display the signal level. Use the DAT
A
buttons to select the desired beam.