Instruction manual

Fieldbus Interface
108
Output Array bytes 0 and 1 Operating Mode Command - continued
Byte Bit Function Value
Switchpad
Type
(Param 51)
Action Performed
0
1 Input B
1
0
Select Input B and Automatic mode.
Note: To select Centerline mode, set the Input A and B
command bits to 0 and the Centerline command bit to 1.
1
Select Input B and Automatic mode.
Note: To select Centerline mode, set the Input A and B
command bits to 1 and the Input C command bit to 0.
2
Select Input B.
Note: To select Centerline mode, set the Input A and B
command bits to 1 and the Input C command bit to 0.
0 x No change.
0
Input C
or
Centerline
1
0 Select Centerline mode and Automatic mode.
1 Select Input C and Automatic mode.
2 Select Input C.
0 x No change.