User`s guide

Setting Up The PHD ULTRA
™
With EZ PRO
™
PHYSICAL VIEWS
The following diagrams show the important components of the PHD ULTRA
™
pump.
Figure 1: Rear view of the PHD ULTRA
™
pump showing important connections.
Figure 2: Front view of the PHD ULTRA
™
pump with important components and controls.
POWER CONNECTIONS AND PUMP STARTUP
The operating voltage range for the PHD ULTRA
™
is 100 - 240 VAC, 50/60 Hz. Use only the specified line
cord for this product and make sure line cord is certified for country of use.
1. Plug the power cord into the Universal Power Input connector on the rear of the PHD ULTRA
™
.
2. Turn on main power switch located in the upper left corner of the rear panel.
3. The PHD ULTRA
™
touchscreen display will illuminate and display the startup screen while performing
initial self-diagnostics. When complete, the unit will display either the Quick Start screen or the
Method Main screen.
Fuse Holder
Main Power Switch
C
onnector for Remote
M
echanism
(
option)
Analog Control Connector
(option)
RJ11 Connectors for RS-232
(option)
User I/O Connector
Footswitch Input
(switch sold separately)
Universal Power Input
RS-485 Connectors
(For pump-to-pump communication)
RS-232 Serial Input USB Serial Input
(For communication from PC)
A
llen wrench
Serial Number Label
Pusher BlockHalf nut Release Knobs
Syringe Barrel Clamp
S
yringe Holder
Bracket Clamp
Knobs
User Interface /
Touchscreen
Run LED
Guide Rods
Vertical Foot
Support
Mechanical
Stops
Lead screw
Harvard Apparatus PHD ULTRA
™
Syringe Pump Series User's Manual
Publication 5419-002-Rev-A
16
S
etting Up The PHD ULTRA™