Specifications

Hardware error. ID Table parity error.00h83h4h
Hardware error. Command timeout.00h82h4h
Hardware error. Internal logic error. 00h81h4h
Hardware error. Buffer CRC Error in writing from buffer to media. 00h44h4h
Degrade Mode. RAM Microcode Not Loaded. 85h40h4h
Degrade Mode. Diagnostic Fail. Reserved area validity check fail.80h40h4h
Hardware error. Unable to update self-test.04h3Eh4h
Hardware error. Self-test failed.03h3Eh4h
Hardware error. No defect spare location available. This sense code indicates
that REASSIGN BLOCKS command fails because all spare sectors have been
used.
00h32h4h
Hardware error. Defect list error. 00h19h4h
Hardware error. Unrecovered read error in reserved area. 00h11h4h
Hardware error. Write fault. 00h03h4h
Hardware error. No seek complete.00h02h4h
Medium error. Medium format corrupted.00h31h3h
Medium error. Defect list error. A defect list error occurs when a data error is
detected while reading the manufacturing defect list or while reading or writing
the grown defect list.
00h19h3h
Medium error. Data synchronization mark error. (DAM error)00h16h3h
Medium error. Defect in servo area00h15h3h
Medium error. Unrecovered read error.00h11h3h
Medium error. ID CRC error.00h10h3h
Medium error. Write fault. 00h03h3h
Not ready. Voltage failure. 00h65h2h
Diag Fall - RAM microcode not loaded.85h40h2h
Diag Fall - Bring-Up failure or degraded mode.80h40h2h
Not ready. Medium format corrupted.00h31h2h
Not ready. Self-test in progress.09h04h2h
Not ready. Format in progress.04h04h2h
Not ready. Initializing command (START STOP UNIT command) required02h04h2h
Not ready. In process of becoming ready.01h04h2h
Not ready. Start spindle motor fail.00h04h2h
DescriptionQualCodeKey
Figure 201. Sense Key / Sense Code / Qualifier combinations (2 of 4)
Ultrastar 146Z10 hard disk drive specifications
219