User`s manual

A-3
After you click Next (or
if you have previously
instructed Windows to al-
ways check the Windows
Update web site for driv-
ers), you'll see the screen
shown to the right.
This screen is used to tell
Windows where to look
for the drivers it needs.
We recommend using the
first selection, Install the
Software Automatically.
Note that whenever possible we recommend you use the drivers available
through the Windows Update web site as this is the easiest method for load-
ing the drivers. However, if you are not able to use the Windows Update
web site, the drivers are also available on the Downloads section of the
JAMAR web site and PETRAPro installation CDs for versions later than
1.5.0. If you are downloading the drivers from the JAMAR web site, be sure
to follow the directions listed there. If you would like to use the drivers on
the PETRAPro CD, insert the CD into your drive.
Once you are ready to pro-
ceed, click Next. The Wiz-
ard will then start searching
for the best available drivers
and you'll see a screen like
the one shown to the right.