Instructions / Assembly

Issued/Revised:
22
FOOTING DETAIL - ONGROUND
2
1
34
2
5
1
CM
0
INCH0
10961114815
7
12 13
4
365
01/31/19
800.458.5872
www.ultraplay.com
1. Attach Upright Posts to Footbuck Ass'ys using M10 x 50mm B.H.C.S. and M10 T-Nut. Making sure to use the top two holes in Footbuck
Ass'y. See Detail 009. Peen T-Nut using hammer to conform around Upright Post.
2. Attach Platform Mounting Bracket to Platform Onground Bracket using M10 x 35mm B.H.C.S. and M10 Lock Nut. See Detail 010.
3. Attach Play Ramp Mounting Bracket to Platform Onground Bracket using M10 x 35mm B.H.C.S. and M10 Lock Nut. See Detail 084.
4. Attach Slide Mounting Bracket to Slide Onground Bracket using M10 x 35mm and M10 Lock Nut . See Detail 016.
5. Continue to assembling unit. Refer to 25 to 51.
6. With Footbuck Ass'ys and Platform Onground Bracket in position, secure each Footbuck Ass'y and Platform Onground Bracket to the
ground using Ground Spikes. NOTE: A 4lb. hammer may be required to drive spikes into the ground. Install ground spikes angled inward
as shown in illustration. See Detail 008. IMPORTANT: Refer to Post Placement/Hole Locations diagram to mark locations of Footbuck
Ass'ys and Platform Onground Bracket.
008
FOOTBUCK
ASS'Y
GROUND SPIKE
(02-07-0048)
010
PLATFORM MOUNTING
BRACKET
PLATFORM ONGROUND
BRACKET
M10 x 35mm (1 3/8")
BHCS BOLT
(33-11-0005)
M10 LOCK NUT
(33-11-0400)
016
SLIDE ONGROUND
BRACKET
SLIDE MOUNTING
BRACKET
M10 x 35mm (1 3/8")
BHCS BOLT
(33-11-0005)
M10 LOCK NUT
(33-11-0400)
009
M10 T-NUT
(33-11-0402)
Peen T-Nut using a hammer
after tightened to conform
around Upright Post.
M10 x 50mm (2")
BHCS BOLT
(33-11-0010)
UPRIGHT
POST
FOOTBUCK
ASS'Y
084
PLATFORM ONGROUND
BRACKET
PLAY RAMP MOUNTING
BRACKET
M10 x 35mm (1 3/8")
BHCS BOLT
(33-11-0005)
M10 LOCK NUT
(33-11-0400)