Use and Care Manual

5.8 Component Test
The Component Test function allows initiating a leak test for
the vehicle's EVAP system. The scan tool itself does not perform
the leak test, but commands the vehicle's on-board computer
to start the test. Different vehicle manufacturers might have
different criteria and methods for stopping the test once it has
been started. Before starting the Component Test, refer to
the vehicle service manual for instructions to stop the test.
1. Use the Up/Down scroll button to select
Component Test from Diagnostic Menu (See
Figure 5.4) and press the OK button.
2. Wait for the scan tool to display the Component Test menu.
Component Test
Evap Leak Test
?
Figure 5.47
[e-mail]
66
1-800-348-5004