Use and Care Manual

Recording Data
The Record Data function allows recording vehicle modules’
Parameter Identification Data (PID) to help diagnose intermittent
vehicle problems. A recording includes 5 frames of live data
before trigger event and several frames after trigger event.
There are two trigger modes used to record data:
1. Manual Trigger - allows user to press
the OK button to start recording.
2. DTC Trigger - automatically records PID data when a
fault that causes a DTC to set is detected by vehicle.
CAUTION:
DO NOT try to drive and operate the Scan
Tool at the same time! Always have another
person operate the Scan Tool while driving.
To record live data, use the Up/Down scroll button
to select Record Data from Live Data menu (See
Figure 5.12) and press the OK button.
Recording Complete Data Set
1. To record a complete set of live data, use the Up/
Down scroll button to select Complete Data Set from
Record Data menu and press the OK button.
………………..Record Data 1/3..
Complete Data Set
Custom Data Set
Unit of Measure ?
Figure 5.20
[e-mail]
45
1-800-348-5004