Use and Care Manual

Emissions Tests vary depending on the geographic or regional
area in which the vehicle is registered. So the Scan Tool provides
a more flexible way to meet different standards, which allows
the user to select 0, 1, 2, 3 and 'not complete' monitors in test.
Reset Factory Default
From Configure Monitors screen, use the Up/Down scroll button
to select Reset Factory Default, and press the OK button.
It will restore the default configuration settings in the Configure
Monitors menu, and delete any customized settings.
In this case, Spark IGN Required Monitors and Compression
IGN Required Monitors will include all the available
monitors, and the Allowed INC Monitors will be set to 1.
The tool will display a message asking for confirmation.
Select Yes to proceed and No to exit without change.
Unit of Measure
•Metric is the default measurement unit.
1. From System Setup screen, use the Up/Down scroll button
to select Unit of Measure and press the OK button.
2. From Unit of Measure screen, use the Up/Down scroll button
to select the desired unit of measurement. (
See Figure 3.6)
3. Press the OK button to save your selection
and return to previous menu.
[e-mail]
22
1-800-348-5004