Use and Care Manual

Mode $06 – Non-Continuously Monitored Systems test
results. There are typically a minimum value, a maximum value,
and a current value for each non-continuous monitor. This data is
optional, and it is defined by a given vehicle maker if it's used.
Mode $07 – Request for DTCs (pending) from Continuously
Monitored Systems after a single driving cycle has been
performed to determine if repair has fixed a problem.
This is used by service technicians to verify repair was
performed properly and after clearing DTCs.
Mode $08 – This special Control Mode requests control of
the on-board system, test, or component bi-directionally
(where applicable). This mode is manufacturer specific.
Mode $09 – Reports vehicle information. This
information includes vehicle VIN number and calibration
information stored in the vehicle ECUs.
Mode $0A – Request Emission-Related Diagnostic Trouble
Codes with Permanent Status. This mode is required for all
emissions-related DTCs. The presence of permanent DTCs at
an inspection without the MIL illuminated is an indication that a
proper repair was not verified by the on-board monitoring system.
[e-mail]
12
1-800-348-5004