Full Product Manual

6.3 LED and Audio Tone Interpretation
Select Ready Test from the Main Screen (See Figure 3.1)
and the screen shows as below, including applicable monitors
status, MIL state, Ignition type, DTCs (stored and pending).
Figure 6.2
If the Scan Tool is idle, it will show the result immediately. If
it is busy, it will wait until the current procedure is finished.
After viewing the status, press ESC button to exit.
“OK” -- Indicates that a particular monitor being
checked has completed its diagnostic testing.
“INC” -- Indicates that a particular monitor being
checked has not completed its diagnostic testing.
“N/A” -- The monitor is not supported on the vehicle.
The LED and audio tone indications are interpreted as below:
[e-mail]
75
1-800-348-5004