Full Product Manual

2. Typical Retrieval of I/M Readiness
a. Use the Up/Down scroll button to select I/M Readiness from
Diagnostic Menu and press OK button. (See Figure 5.4)
b. Wait a few seconds while the Scan
Tool validates the PID MAP.
c. If the vehicle supports both types of tests, then both
types will be shown on the screen for selection.
……………I/M Readiness 1/2.
Since DTCs Cleared
This Drive Cycle ?
Figure 5.34
d. Use the Up/Down scroll button, as necessary,
to view the status of the MIL light (“ON” or
“OFF) and the following monitors:
[e-mail]
57
1-800-348-5004