Full Product Manual

CHARGING THE POWER PACK
WARNING! Always charge on a non-flammable surface.
1. Press and hold the Battery Test Button on the front of the unit to check the battery
power level.
a. 13-15 volts is ready for use.
b. 12 volts needs to be charged.
c. Less than 12 volts should be charged immediately.
2. Turn the Clamp Power Switch on front of unit to the OFF position.
3. Plug the 120VAC Adapter into a 2 or 3-prong outlet. (See Figure B.)
4. Plug the Adapter cord into the Charging
5. Allow the time needed to charge, periodically checking the Voltmeter.
Input on the front of the unit.
Note: Before initial use, completely charge the Power Pack as indicated for Initial Charge.
(See Figure C.)
NOTE: FAILURE TO RECHARGE POWER PACK WILL VOID WARRANTY.
6. When the Power Pack is fully charged, unplug the Adapter from the outlet and the Power Pack.
7. Recharge for length of time as indicated for Recharge: (See Figure C.)
a. When voltage drops to 12 volts.
b. After each Jump-Start..
c. Once a month.
8. The Charging Indicator light will illuminate when the unit is charging. The Charging Indicator
light will turn off when the charging is complete. The Voltmeter must be checked periodically
when charging and the Power Pack must be unplugged when the unit is fully charged.
DO NOT EXCEED MAXIMUM CHARGING TIME.
[e-mail]
6
1-800-348-5004
Figure B Figure C
AC Charge Time
Initial Charge:
48 hours
Recharge:
34 hours