Full Product Manual

PERSONAL SAFETY
1. Wear ANSI-approved splash-resistant safety goggles and heavy-duty
rubber work gloves whenever connecting, disconnecting, or working
near battery. Battery acid can cause permanent blindness. Avoid
touching eyes while working near battery.
2. Do not use Power Pack while you are tired or under the influence of drugs, alcohol
or medication. A moment of inattention while operating Power Pack may result in serious
personal injury.
3. NEVER smoke or allow a spark or flame in vicinity of battery or engine.
4. If battery acid contacts skin or clothing, wash immediately with soap and water. If
acid enters eye, immediately flood eye with running cold water for at least 10 minutes
and get medical attention immediately.
5. Remove personal metal items such as rings, bracelets, necklaces, and watches when
working with a lead-acid battery. A lead-acid battery can produce a short-circuit current
high enough to weld a ring or the like to metal, causing a severe burn.
6. People with pacemakers should consult their physician(s) before use. Electromagnetic fields in
close proximity to heart pacemaker could cause pacemaker interference or pacemaker failure.
SERVICE
POWER PACK SAFETY WARNINGS
1. Lead-acid batteries generate hydrogen gas when charging. Hydrogen gas is explosive.
Only use the Jump-Start system in a well-ventilated area.
2. Never exceed the maximum charging time of the Power Pack.
3. Jump Starting A Vehicle
a. Use the Power Pack for jump starting
a LEAD-ACID battery only.
b. For emergency use only. Do not use the Power Pack as a replacement for a vehicle battery.
c. Be sure area around battery is well ventilated while battery is being jump started.
d. NEVER jump start a frozen battery.
e. Do not attempt to jump start a vehicle with a non-rechargeable or defective battery.
f. Study all battery manufacturer’s specific precautions for jump starting.
g. DO NOT TOUCH POSITIVE AND NEGATIVE BATTERY CLAMPS TOGETHER.
h. Unplug the Power Pack from its Adapter before connecting its cables to a battery.
i. Connect and disconnect battery cable clamps only after setting any Jump Starter switches
to OFF position.
j. Connect cables to proper polarities. Connect black cable to negative body ground and
red cable to positive battery terminal.
k. Locate Power Pack as far away from battery as battery cables permit.
4. Inverter
a. DO NOT OPEN HOUSING. Contains no user-serviceable parts. Internal parts may
be electrified, even with unit off.
b. Do not use the Inverter to power sensitive devices such as medical devices. Do not use
in ignition protected areas
Have your Power Pack serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the Power Pack is maintained.
[e-mail]
3
1-800-348-5004