Full Product Manual

SPECIFICATIONS
GENERAL SAFETY WARNINGS
Read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases
during normal battery operation. For this reason, it is of utmost importance that you follow the
instructions each time you use the Power Pack.
WORK AREA SAFETY
1. Keep work area clean and well lit. Cluttered or dark areas invite accidents.
2. Do not operate Power Pack in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust. The Power Pack can create sparks which may ignite
the dust or fumes.
3. Keep children and bystanders away while operating the Power Pack. Distractions can
cause you to lose control.
4. Store idle equipment. Always lock up tools and keep out of reach of children.
ELECTRICAL SAFETY
1. Do not drop a metal tool onto battery. It might spark or short-circuit battery or other
electrical part that may cause explosion.
2. Do not operate if Power Pack has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified technician.
3. Do not leave Power Pack unattended while switched on. It could result in fire and property
damage.
4. Do not expose to rain or wet conditions. Water entering the Power Pack will increase the
risk of electric shock.
5. Do not use an extension cord with this item.
6. Use of an attachment not recommended or sold by the manufacturer may result in a
risk of fire, electric shock, or injury to persons.
7. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting the Adapter.
8. Do not operate with damaged cord or plug. Replace the cord or plug immediately.
To reduce risk of battery explosion, follow these instructions and those published by battery
manufacturer and manufacturer of any equipment you intend to use in vicinity of battery.
Review cautionary marking on these products and on engine.
WARNING – RISK OF EXPLOSIVE GASES.
[e-mail]
2
1-800-348-5004
AC Output
Power
Continuous 200W
Peak 400W
Voltage 115V
Frequency 60Hz
Wave Form
Modified Sine Wave
(non-sinusoidal)
Inverter No
Load Current
<0.5A (battery drain with
no load on Inverter)
Battery 12V, 18Ah, Sealed Lead-Acid
Booster Cables 26″ L With Copper-Plated Clamps
Fuse 12V 40A
Low Voltage
Warning
<10.8V - 11.3V
Low Voltage
Shutdown
8.9V - 9.4V
Functions: 12 Volt Jump-Starter,
300 PSI Air Compressor, 200W Power
Inverter, Power Supply, and Work Lights