Full Product Manual

[e-mail]
6
1-800-348-5004
Over discharge protection:
If the product is in heavy load discharge mode continuously when you start the car, it will provide following
protection:
a. when the voltage is 5-10V and the discharge time is more than 5S
b. when the voltage is 3-5V/1s
c. when the voltage is lower than 3V, please try other ways to start
Over heat protection:
If the internal temperature of product is over than 140°F, the product will protect itself. It will show jump cable,
USB port and LED light are no output current, fault indicator will twinkle and with “bee bee” buzzer warning.
The product begin to work normally if the internal temperature is lower than 122°F.
Over load protection:
The product will stop automatically if the USB port is overload and the current is over than 2.3A, USB
port will stop and will sound “bee bee”. the product will shut off automatically.
(10)Touch switch
Press the switch and the product starts. After starts, the switch can be adjustable for the flashlight modes:
lasting light, flashing and stop. The product will shut down without any operations for 120S. Press the touch
switch for 2s, the prouduct will shut off.
(11) LED light
LED type: highlight LED
LED quantity: 1 pc
Power: 0.5W
(12) Status display way: LED indicator
LED quantity: 5 pcs
Three blue LED indicators show battery capacity for 30%, 60% and 100% One red indicator shows fault
indicator, One double color ( yellow and green) LED indicator: yellow shows product is in preheating mode,
green shows product is in start waiting mode.
(13) Accessory：
Multi-functional USB cable ( for IPad, Sumsung and mini USB port)
Length: 8.26in
Black flannelette bag
3.Temperature range:
Operating temperature range: -4°F-140°F
Storage temperature range: 32°F-113°F
Functions
1. Switch: Products will enter the sleep mode automatically after 2 minutes without any operation. Press “on/off ”
button to activate. Press “on/off “ button again, “LED light” will change the mode. There are three modes of LED
light: on, strong flash and off. Press “on/off “ button for more than 2 seconds, products will shut off .
2. Micro USB charging port: apply the USB line, charging side is connected with Micro USB charging port, the
other side is plugged in 5V 2.1A electricity supply. Three indicator lights will be on one by one during the
charging process. Until three lights are all on, the product is fully charged.
3. USB discharging port: plug the USB cable in the port; the other three ports on the other side can be connected
with different devices for charging purpose.
4. Turn on the switch, plug the auto starting line in startup port (if products’ working temperature is below 50 °F,
products will enter preheating procedure automatically, while at the same time, the preheating and startup
indicator light will turn yellow. The yellow light will be off until the working temperature reaches 50°F and clip
on car battery. The red clip should be clipped to positive pole of the battery, while the black clip should be
clipped to negative pole. Please make sure both connections are tight and in a good condition. At the same
time, the startup light should turn to green. Afterwards, start the car engine.
5. After start procedure, disconnect from car battery, disconnect between products and clips.