Full Product Manual

Caution: Surges and sparks in electrical power supply could
possibly cause battery explosion.
14. Battery charger should be plugged into a surge protector outlet.
Battery float charger: 12 volts DC, 5 to 125 amp hours.
Voltage output: 13.5 VDC
Dimensions: 1-3/4 x 1-1/2 x 2-1/4 inches
Total length from power module to connector clips: 81 inches
Input voltage: 120 volts AC, 60Hz, 14 watts
Specifications
1. Place float charger within 5 feet of battery.
2. Connect red clip to positive (+) terminal of battery.
3. Connect black clip to negative (-) terminal of battery.
4. When the adapter is connected to the power, the red light
(power light) will be lighted.
5. The green light will be lighted when the clamps are connected
to the terminals on battery.
6. After the battery is fully charged, the green light will be went out.
7. Plug power module into electrical outlet.
Caution: If the parts box is to be mounted on a sub-plate,
do not use a power driver. To mount the parts box, use the
2 rubber washers and 2 phillips head screws (not included) and
hand tighten into place.
Operation
Caution: Batteries can explode under certain conditions; excessive
heat and/or poor ventilation can cause battery explosion.
1. Unplug the AC adapter
2. Remove the black clip, then the red clip from the battery
After Use
[e-mail]
3
1-800-348-5004